Finally got my 66thou Cometic gasket for the moke. 99% of the hole line up perfectly except for a water hole in head and block near the engine steady close to 4th cyl.

For reference this is a big bore gasket onto a small bore engine the bk450 fit fine.

What do I use to 'plug' these holes?

_________________
Here am I sitting in my tin can far above the Moon
Planet Earth is blue and there's nothing I can do...



“A turbo: exhaust gasses go into the turbocharger and spin it, witchcraft happens and you go faster.” - Jeremy Clarkson

Drill and tap for a brass plug, screw it in with loctite then deck it flush.
How I did Joe's 1108 with 68mm bore. Using a 202 head and bk450 gasket.
Edit
After you plug and deck it you can drill the hole where wanted.

PM sent.

_________________
DrMini- 1970 wasaMatic 1360, Mk1S crank, 86.6HP (ATW) =~125 @ crank, 45 Dellorto (38 chokes), RE282 sprint cam, 1.5 rockers, 11.0:1 C/R.