| ausmini https://ausmini.com/forums/ |
|
| Linkage for twin SU's (non S) https://ausmini.com/forums/viewtopic.php?f=5&t=9821 |
Page 1 of 1 |
| Author: | coops [ Sat Aug 06, 2005 4:35 pm ] |
| Post subject: | Linkage for twin SU's (non S) |
ok im bored at home i have a spare twin 1.1/4 inlet manifold but only two of the same carb just standards. question is how do i link them up can i turn the shaft around in one and use standard linkage or how do i go about it? gt1310 might get this one as he has a set 
cheers harley |
|
| Author: | drmini in aust [ Sat Aug 06, 2005 5:26 pm ] |
| Post subject: | |
Go to a carb place, you need 2 `W' clips... and a bit of steel rod between. 
|
|
| Author: | GT1360 [ Sat Aug 06, 2005 5:57 pm ] |
| Post subject: | |
yeah. what Doc said.. 
|
|
| Author: | coops [ Sat Aug 06, 2005 8:59 pm ] |
| Post subject: | |
thanks kev
oh and cody 
cody i know you were selling yours if they are off the car maybe you could take a photo for me and email it to me 
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|