ausmini
https://ausmini.com/forums/

Flare experts congregate
https://ausmini.com/forums/viewtopic.php?f=5&t=94469		 Page 1 of 1
Author:  Alexw [ Sat Dec 24, 2016 10:16 am ]
Post subject:  Flare experts congregate
I have a set of flares that I've inherited, and I'm almost ready to fit them.

They are fibreglass, and it's reasonably clear which are the fronts and rears (fronts have a wider flare at the bumper end)

The fronts look like they will fit properly, but the rears look wrong.

The radius of the flare seems too large at the rear - see pictures.

Note that the pictures are not of the mini that they will be fitted to!

front:

Image


rear:

Image


Anyone had experience here before?

Thanks all
Author:  zulu_warrior1976 [ Sat Dec 24, 2016 10:24 am ]
Post subject:  Re: Flare experts congregate
Could they be for 13's? On a mini that has had its guards cut?
Author:  simon k [ Sat Dec 24, 2016 9:54 pm ]
Post subject:  Re: Flare experts congregate
your pictures are too small to see clearly, but they look like a set of flares I have in my collection... the rear sits down on the bumper seam and they sit pretty low, below the seam over the wheel arch
Author:  Alexw [ Sun Dec 25, 2016 7:46 pm ]
Post subject:  Re: Flare experts congregate
They are a bit small. here is larger:

Front
Image

Rear
Image

Not sure what you mean by low - if they are installed with the two ends in the right place, then the middle will be 30+mm lower than the original arch..

It's like the radius is just wrong.

Alternatively, what flares to people recommend getting that add around 40mm of width?

Cheers
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/