Well , I finished making installation tool for cam bearings today, very happy with the result , new bearings installed in race motor.
| ausmini https://ausmini.com/forums/ |
|
| camshaft installation tool https://ausmini.com/forums/viewtopic.php?f=5&t=90146 |
Page 1 of 1 |
| Author: | 69cooper [ Sun Aug 02, 2015 8:25 pm ] |
| Post subject: | camshaft installation tool |
What do the guru's use to install camshaft bearings ?, does anyone know were you can buy them ? , or are their any design I can copy. Cheers mal |
|
| Author: | TK [ Sun Aug 02, 2015 8:43 pm ] |
| Post subject: | Re: camshaft installation tool |
hydraulic press |
|
| Author: | kiwiinwgtn [ Sun Aug 02, 2015 9:06 pm ] |
| Post subject: | Re: camshaft installation tool |
I was going to make on of these tools the next time I need to do the cam bearings. I am sure if you search the web you can find some more drawings http://www.3dcontentcentral.com/downloa ... &id=423572 Hope this helps Kiwiinwgtn |
|
| Author: | drmini in aust [ Sun Aug 02, 2015 9:31 pm ] |
| Post subject: | Re: camshaft installation tool |
kiwiinwgtn wrote: I was going to make on of these tools the next time I need to do the cam bearings. I am sure if you search the web you can find some more drawings http://www.3dcontentcentral.com/downloa ... &id=423572 Hope this helps Kiwiinwgtn Graham Russell uses a similar kit, not sure where he got it from. Works well. No press needed. |
|
| Author: | kiwiinwgtn [ Sun Aug 02, 2015 9:39 pm ] |
| Post subject: | Re: camshaft installation tool |
http://www.dummett.net/ime/website/ime/c/cam.html the dimesions are listed here. |
|
| Author: | boomini [ Wed Aug 05, 2015 7:46 pm ] |
| Post subject: | Re: camshaft installation tool |
Surely you could machine up some press tools on your lathe malcom... |
|
| Author: | 69cooper [ Wed Aug 05, 2015 8:00 pm ] |
| Post subject: | Re: camshaft installation tool |
Will be making up a set Friday |
|
| Author: | SCA1PER [ Thu Aug 06, 2015 1:11 pm ] |
| Post subject: | Re: camshaft installation tool |
Ac |
|
| Author: | 69cooper [ Sun Aug 09, 2015 9:41 pm ] |
| Post subject: | Re: camshaft installation tool |
Well , I finished making installation tool for cam bearings today, very happy with the result , new bearings installed in race motor.
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|