I usually aim for 4-5 thou. But I'd not waste $$ just to get from 6 thou to 5..
| ausmini https://ausmini.com/forums/ |
|
| 1275 primary gear end float? https://ausmini.com/forums/viewtopic.php?f=5&t=87831 |
Page 1 of 1 |
| Author: | TimW [ Sun Nov 23, 2014 10:41 pm ] |
| Post subject: | 1275 primary gear end float? |
After reading up on the end float tolerances for the primary gear I am little uncertain what I should be aiming for. The standard tolerance is 3 thou to 6 thou and Calver suggests 5 thou for performance engines and 4 thou for every day driving. My engine is 1275 with RE 83 cam and ported head by GR, so it will be a modestly quick street car. Any suggestions? The current float is 6 thou with a new c washer and new 114 thrust washer and I was thinking of taking it down to 4 with a new thrust washer (116 thou). Expensive little thing they are....... Welcome any suggestions |
|
| Author: | drmini in aust [ Mon Nov 24, 2014 10:39 am ] |
| Post subject: | Re: 1275 primary gear end float? |
I usually aim for 4-5 thou. But I'd not waste $$ just to get from 6 thou to 5..
|
|
| Author: | dalmeny [ Sun Nov 30, 2014 7:38 pm ] |
| Post subject: | Re: 1275 primary gear end float? |
Just bought a new thrust from Ben at Mini Plus. He got them at a good price. |
|
| Author: | Keith C [ Mon Dec 01, 2014 3:36 am ] |
| Post subject: | Re: 1275 primary gear end float? |
Don't bust a gut, 0.006" is fine. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|