| ausmini https://ausmini.com/forums/ |
|
| re-13 lift https://ausmini.com/forums/viewtopic.php?f=5&t=8104 |
Page 1 of 1 |
| Author: | steveandsash [ Wed Jun 15, 2005 12:06 am ] |
| Post subject: | re-13 lift |
just wondering what the full valve lift of the re-13 cam is? i have just bought a set of minispares forged 1.5 ratio rockers (actual ratio is 1.58 i'm told) my valve springs are good for .490" and 8000rpm lift just wanna do the calculations and find out if i am going to run into coil bind dramas or not. cheers steve |
|
| Author: | drmini in aust [ Wed Jun 15, 2005 7:05 am ] |
| Post subject: | |
Look in this thread. http://www.ausmini.com/forums/viewtopic ... ht=rockers ON p1 I posted lift figures for an RE-13 cam, with S forged rockers, Toyota Corolla (1.46) rockers, and MS forged 1.5 rockers. Your lift is 0.450", those springs etc will be fine, that's what I'm running. 
Set rocker clearance to .020" to start with- after it's run in, try reducing clearance to .018". |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|