| ausmini https://ausmini.com/forums/ |
|
| MG Metro conrods https://ausmini.com/forums/viewtopic.php?f=5&t=76511 |
Page 1 of 1 |
| Author: | 1962CKD [ Tue Apr 24, 2012 12:01 pm ] |
| Post subject: | MG Metro conrods |
Can anyone give me the specs on a 1275 MG Metro con rod big end, small end, and length C-C? |
|
| Author: | lmbm [ Tue Apr 24, 2012 6:15 pm ] |
| Post subject: | |
Hi, sizes are the same as a normal and heavy 1275 ( non S ) rod . Big End 1.8955" Small End/pin bore: 0,8125" center to center : 5.75" Hope this helps. Cheers Luis |
|
| Author: | 1962CKD [ Tue Apr 24, 2012 10:24 pm ] |
| Post subject: | cool |
Thanks I'm getting some made and wanted to confirm specs. |
|
| Author: | GT mowog [ Thu Apr 26, 2012 2:25 pm ] |
| Post subject: | Re: cool |
1962CKD wrote: Thanks I'm getting some made and wanted to confirm specs.
You'll also need the off-set. |
|
| Author: | Mokesta [ Thu Apr 26, 2012 5:03 pm ] |
| Post subject: | Re: cool |
GT mowog wrote: 1962CKD wrote: Thanks I'm getting some made and wanted to confirm specs. You'll also need the off-set. It would be a bugger of an Oops moment if the offset was forgotten! Good point GT. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|