I'd talk to Keith Calver, he gets Piper cams in UK to grind Graham Russell's cam profiles for him.
http://www.calverst.com/shopopen.htm
See his RE13PP one.
| ausmini https://ausmini.com/forums/ |
|
| which cam for a 1360 https://ausmini.com/forums/viewtopic.php?f=5&t=37992 |
Page 1 of 1 |
| Author: | titi de lille [ Tue Nov 20, 2007 7:32 pm ] |
| Post subject: | which cam for a 1360 |
hi, I built a 1360 with a 31/36 cylinder fully flowed and shape chamber.the cr will be 10.8 and a hl 1.5 and a 3.11 gear box. I would like an engine nervous and torquey. and I don't run over 7000rpm since july I try to buy a morspeed trackday camshaft but, it's very very hard to have one. which one do you advise me? |
|
| Author: | drmini in aust [ Tue Nov 20, 2007 7:44 pm ] |
| Post subject: | |
I'd talk to Keith Calver, he gets Piper cams in UK to grind Graham Russell's cam profiles for him. http://www.calverst.com/shopopen.htm See his RE13PP one.
|
|
| Author: | TheMiniMan [ Tue Nov 20, 2007 9:47 pm ] |
| Post subject: | |
I`d say you`d be hard pushed to get it to rev anywhere near 7000rpms in top gear with that 3.1:1 diff ratio anyways, but yes defantely talk with keith Calver before you build it. |
|
| Author: | titi de lille [ Tue Nov 20, 2007 11:18 pm ] |
| Post subject: | |
in my previous engine , I had a morspeed trackday cam, but a lobe was destroy after 300km and I don't know why.... I was very happy from it, but now I can't succed in find an other one... I try to phone to morspeed but impossible... if this week I can't phone to simon, I 'll the cam from keith.... |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|