ausmini https://ausmini.com/forums/ |
|
ground clearance https://ausmini.com/forums/viewtopic.php?f=5&t=36240 |
Page 1 of 1 |
Author: | andywado [ Sun Sep 30, 2007 6:04 pm ] |
Post subject: | ground clearance |
I was reading the manual and it says the ground clearance should be around 6 ins Ive got about 4 it looks cool but F#&K its low what do I do to get the height back up to spec? |
Author: | drmini in aust [ Sun Sep 30, 2007 7:51 pm ] |
Post subject: | |
If it's still hydro suspension, you get it pumped up by someone with a hydro pump. I've got one- but Can-Bra is a bit far to go, check out your local Mini club. ![]() |
Author: | andbat [ Sun Sep 30, 2007 8:00 pm ] |
Post subject: | |
and if it not hydro. replace the rubber thingos or install adjustable cones, or both. right doc.? |
Author: | 1018cc [ Sun Sep 30, 2007 8:21 pm ] |
Post subject: | |
andbat wrote: and if it not hydro. replace the rubber thingos or install adjustable cones, or both. right doc.?
Translation: If you have dry suspension try replacing the rubber cones or install Hi-Lo's (or similar) or both. Your cones might be fine (I doubt it unless you have replaced them recently) and some one has cut down the trumpets thus lowering the car. |
Author: | andywado [ Sun Sep 30, 2007 8:57 pm ] |
Post subject: | |
It's a hydro Doc. The displacers seem ok. A pump up might do the trick you think? |
Author: | 9YaTaH [ Sun Sep 30, 2007 9:01 pm ] |
Post subject: | Yep |
andywado wrote: It's a hydro Doc. The displacers seem ok. A pump up might do the trick you think?
Yes...it could do...unless the front trumpets have punched through there cups/mountings...the club has a pump as does Melba Mtrs. |
Author: | buztoy [ Sun Sep 30, 2007 9:15 pm ] |
Post subject: | |
Quote: adjustable cones
are there really ![]() ![]() |
Author: | drmini in aust [ Sun Sep 30, 2007 9:31 pm ] |
Post subject: | |
buztoy wrote: Quote: adjustable cones are there really ![]() ![]() He means Hi-Los. ![]() |
Page 1 of 1 | All times are UTC + 10 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |