Keith i just had a look at your site and couldn't see it there
Anychance of a link. Hope the weather isn't freezing your butt off too much. 
Cheers
Aaron
PS Aiden say's "hello"
| ausmini https://ausmini.com/forums/ |
|
| Carb jet conversion https://ausmini.com/forums/viewtopic.php?f=5&t=28753 |
Page 1 of 1 |
| Author: | Keith Calver [ Fri Mar 02, 2007 9:31 pm ] |
| Post subject: | Carb jet conversion |
For all those that have pestered me about this jet conversion to change the waxstat on single 1.5" SU to the plastic jet type - I now have them in hand in 'shop' on my site under carburettor. KC |
|
| Author: | aaron [ Fri Mar 02, 2007 10:04 pm ] |
| Post subject: | |
Keith i just had a look at your site and couldn't see it there Anychance of a link. Hope the weather isn't freezing your butt off too much.
Cheers Aaron PS Aiden say's "hello" |
|
| Author: | Keith Calver [ Fri Mar 02, 2007 11:08 pm ] |
| Post subject: | |
Hell Aaron... Go to the shop, select Carburretor... it's there. You should know better than to ask me for technical stuff on computers! KC |
|
| Author: | aaron [ Sat Mar 03, 2007 7:49 am ] |
| Post subject: | |
Yes i know, one day will learn how to use ths new fangled computer thingy 
It is there now, but there wasn't any carburettor catagory until just now.
Cheers Aaron |
|
| Author: | Keith Calver [ Sat Mar 03, 2007 8:44 am ] |
| Post subject: | |
Tut Tut... and you think you know what you're doimg with computers... Shame on you! Seriously - I waved my magic wand - eemed more reliable than relying on the computer.... KC |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|