Pretty sure they are 0.500" (12.7mm) for stockers, the MiniSport Adjustarides are bigger just to make life difficult....
| ausmini https://ausmini.com/forums/ |
|
| Knuckle joint shank size https://ausmini.com/forums/viewtopic.php?f=5&t=28156 |
Page 1 of 1 |
| Author: | smac [ Fri Feb 16, 2007 9:03 am ] |
| Post subject: | Knuckle joint shank size |
I'm going to look at packing out the rear knuckle joints with washers until I can get my hands on some adjustable trumpets. Does anyone know the size of the knuckle joint shank (that goes into the trumpet), and therefore the ID of the washers I need? Engineers will prolly be closed by the time I get them out tomorrow. |
|
| Author: | drmini in aust [ Fri Feb 16, 2007 3:49 pm ] |
| Post subject: | |
Pretty sure they are 0.500" (12.7mm) for stockers, the MiniSport Adjustarides are bigger just to make life difficult....
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|