| ausmini https://ausmini.com/forums/ |
|
| Can anybody identify this Head? https://ausmini.com/forums/viewtopic.php?f=5&t=23434 |
Page 1 of 1 |
| Author: | fwom moke [ Mon Oct 09, 2006 7:58 am ] |
| Post subject: | Can anybody identify this Head? |
|
|
|
| Author: | sports850 [ Mon Oct 09, 2006 8:09 am ] |
| Post subject: | |
12g940 , 1275 (1100S) head that was on most non cooper s blocks (was on 1275gt with extra stud holes ???) , the normal one people use for a big bore motor . If you do a search for 12G940 there should be a lot of info on here about them , basically a good head and with a little bit of work can fit on a 998/1100 motor for really good breathing . |
|
| Author: | fwom moke [ Mon Oct 09, 2006 8:24 am ] |
| Post subject: | |
its on a rebored 1275 
A+ series block? |
|
| Author: | drmini in aust [ Mon Oct 09, 2006 8:43 am ] |
| Post subject: | |
Hard to tell if A+ from that angle, if dizzy held in with forked clamp and 1 bolt, and there are webs on outside of block, yes it is A+. Like this one- 
|
|
| Author: | fwom moke [ Mon Oct 09, 2006 9:14 am ] |
| Post subject: | |
Can you tell from this angle? 
|
|
| Author: | drmini in aust [ Mon Oct 09, 2006 12:09 pm ] |
| Post subject: | |
Yes, it's A+, you can tell by the position of the 2 rear bracket bolts that hold the alternator. Same as in my pic. 
On an A series they are a few inches further away (originally were for a generator). |
|
| Author: | willy [ Mon Oct 09, 2006 12:12 pm ] |
| Post subject: | |
Very VERY shiny motor! Looks awesome. Was almost every bit on it painted separately before assembly? |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|