Yes, no problem. Bore size and spacing is the same, so is the block.
As the combustion chamber is a little bigger on the K head, I'd deck it 1mm or so or the C/R will be too low.
| ausmini https://ausmini.com/forums/ |
|
| head swap? https://ausmini.com/forums/viewtopic.php?f=5&t=22861 |
Page 1 of 1 |
| Author: | russdog1 [ Sun Sep 24, 2006 11:00 am ] |
| Post subject: | head swap? |
Hi, new to minis, if bore spacings are the same can a 1100k round nose head fit on the later 998 blocks? |
|
| Author: | drmini in aust [ Sun Sep 24, 2006 11:22 am ] |
| Post subject: | |
Yes, no problem. Bore size and spacing is the same, so is the block. As the combustion chamber is a little bigger on the K head, I'd deck it 1mm or so or the C/R will be too low.
|
|
| Author: | russdog1 [ Sun Sep 24, 2006 11:34 am ] |
| Post subject: | |
Thanks drmini for promt reply- Russdog |
|
| Author: | 9YaTaH [ Sun Sep 24, 2006 12:06 pm ] |
| Post subject: | Re: head swap? |
russdog1 wrote: Hi, new to minis, if bore spacings are the same can a 1100k round nose head fit on the later 998 blocks?
russ...got the number off the head  ....you need to take the rocker/tappett cover off and it is cast into the head....12G202 or similar
It may be better to check what head you have, and check with the Doc before you plonk it on to your 998cc...Cheers, Mick |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|