ausmini https://ausmini.com/forums/ |
|
Hose too long? https://ausmini.com/forums/viewtopic.php?f=5&t=15850 |
Page 1 of 2 |
Author: | Marvin [ Sat Feb 04, 2006 4:40 pm ] |
Post subject: | Hose too long? |
This heater hose it getting annoying. I know it shouldn't be that long. ![]() Does anyone have a pic of how it should actually look? Also, is the Hot/Warm/Cold control in the right spot? Should it be screwed/bolted to something? ![]() |
Author: | Morris 1100 [ Sat Feb 04, 2006 7:54 pm ] |
Post subject: | |
Yes that heater tap is in the wrong place... The correct location for that heater tap is under the bonnet of a HZ holden. ![]() The Clubbie heater tap is a POS and they have replaced it with a Holden one. You may be able to mount it better (I doubt if you could mount it worse!) You may be able to mount it the other way up. |
Author: | Marvin [ Sat Feb 04, 2006 8:03 pm ] |
Post subject: | |
![]() |
Author: | Mini Mad [ Sat Feb 04, 2006 8:09 pm ] |
Post subject: | |
Bloody Martians ![]() ![]() |
Author: | Marvin [ Sat Feb 04, 2006 8:12 pm ] |
Post subject: | |
Mini Mad wrote: Bloody Martians
![]() ![]() Hmmm... I think I may have bought the car off a Saturnian ![]() |
Author: | drmini in aust [ Sat Feb 04, 2006 8:46 pm ] |
Post subject: | |
Put it up on the back of motor where you can get at it.. Or do what we did, leave (clubby one) off. ![]() |
Author: | Marvin [ Sat Feb 04, 2006 8:59 pm ] |
Post subject: | |
drmini in aust wrote: Put it up on the back of motor where you can get at it..
Or do what we did, leave (clubby one) off. ![]() So you've got it set at hot all the time? |
Author: | drmini in aust [ Sat Feb 04, 2006 9:00 pm ] |
Post subject: | |
Marvin wrote: drmini in aust wrote: Put it up on the back of motor where you can get at it.. Or do what we did, leave (clubby one) off. ![]() So you've got it set at hot all the time? Yeah but just turn air off in summer, use the 1/4 windows. That's what they're for... ![]() As said, Clubby tap is a right POS... |
Author: | Morris 1100 [ Sat Feb 04, 2006 9:06 pm ] |
Post subject: | |
The Australian Morris 1100 heater does not have a tap. They use the heater for extra engine cooling. When you want hot air you open the flap to let the hot air in the car. |
Author: | Mini Mad [ Sat Feb 04, 2006 9:08 pm ] |
Post subject: | |
Sounds like a 'matic heater too.. |
Author: | drmini in aust [ Sat Feb 04, 2006 9:15 pm ] |
Post subject: | |
Mini Mad wrote: Sounds like a 'matic heater too..
No it's not, if I remember it's in car like a Clubby...?? Clubby has air flap, just leave off unless you want heat. ![]() Hey it's not like it's a UK one with those new-fangled fresh air vents.. Cooper S handbook used to say turn heater on if engine gets too hot.. |
Author: | Morris 1100 [ Sat Feb 04, 2006 9:25 pm ] |
Post subject: | |
Yeah, It is in the car under the dash. The air feeds in from the plenum through the top. |
Author: | gafmo [ Sat Feb 04, 2006 9:30 pm ] |
Post subject: | |
the tap does bugger all anyway..just stuffs the cooling system..let the water run through and all will be sweet and the hose will be nice and short also ![]() |
Author: | Marvin [ Sun Feb 05, 2006 6:27 pm ] |
Post subject: | |
Let's just say that the heater's a whole lot freakin easier to get in than out!!! Well it was once all the extra hoses were gone. ![]() |
Author: | Morris 1100 [ Sun Feb 05, 2006 6:38 pm ] |
Post subject: | |
That looks much better. ![]() Did you keep the tap or remove it? |
Page 1 of 2 | All times are UTC + 10 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |