ausmini
https://ausmini.com/forums/

How to mount the Pulsar Dizzy?????
https://ausmini.com/forums/viewtopic.php?f=5&t=14668		 Page 1 of 1
Author:  Monster Mini [ Fri Jan 06, 2006 9:34 pm ]
Post subject:  How to mount the Pulsar Dizzy?????
Hi Guys,

I just got hold of the new Pulsar N12 dizzy, and have done all of the mods with regards the shaft and so on. The only question that I have is with regards the mounting of the unit to the engine.

Here is a picture of the clamp that came of the old distributor.

Image

Here is a picture of the dizzy mounting braket on the N12

Image

The question is; do I cut off the existing mounting bracket? Then will bracket in the first picture fit around the casing or do I have to file off the fins on the casing as shown here?.....

Image

If someone can point me in the right direction it would be much appreciated. :?
Author:  drmini in aust [ Fri Jan 06, 2006 9:50 pm ]
Post subject: 
OK, you get a hacksaw and cut that lug off. Then file or linish that bit down carefully, until it's the same diameter as the round part- which just happens to be the right size for the clamp.
Make sure the clamp is round inside, people overtighten them and bend the **** out of them.
But yours looks OK. :lol:
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/