ausmini
https://ausmini.com/forums/

1275 cam id
https://ausmini.com/forums/viewtopic.php?f=5&t=12271
Page 1 of 1

Author:  jbeenz [ Tue Oct 18, 2005 6:53 am ]
Post subject:  1275 cam id

hi, i just brough a whole load of stuff (including a 1220 in pieces and a 2.9 diff), but theres a 1275 cam in this lot, it looks to have had very very little use, now i dont feel like pulling down my 1275 to find this out, but should the cam have "8M73" stamped (roughly) onto the end of the cam? its on the threaded end(timing chain end) just tring to find out if this is standard, as none of my small bore cams have any marks at all.
if this dosent sound standard ill have it measured.
thanks

Author:  drmini in aust [ Wed Oct 19, 2005 6:57 am ]
Post subject: 

I'd say the cam has been reground, that's a popular spot to mark them. Check your local cam grind shops for their grind numbers... :wink:

Author:  jbeenz [ Wed Oct 19, 2005 7:45 am ]
Post subject: 

heres hoping its somthing interesting.

Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/