| ausmini https://ausmini.com/forums/ |
|
| Flywheel & TDC https://ausmini.com/forums/viewtopic.php?f=5&t=11680 |
Page 1 of 1 |
| Author: | merps [ Thu Sep 29, 2005 9:07 pm ] |
| Post subject: | Flywheel & TDC |
ok - this is going to be a dumb question. Due the flywheel being keyed, but I am curious to know if it is at all possible to but a flywheel on upside down? eg. 1/4 mark equals BDC on cylinder 1. |
|
| Author: | drmini in aust [ Thu Sep 29, 2005 9:27 pm ] |
| Post subject: | Re: Flywheel & TDC |
merps wrote: ok - this is going to be a dumb question. Due the flywheel being keyed, but I am curious to know if it is at all possible to but a flywheel on upside down? eg. 1/4 mark equals BDC on cylinder 1.
Not, with the later 1 piece flywheel. But, with the early 2 piece ones that had a bolted in centre, yes it can be assembled 180* out. 
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|