| ausmini https://ausmini.com/forums/ |
|
| How do I know if I have a blown head gasket? https://ausmini.com/forums/viewtopic.php?f=5&t=10145 |
Page 1 of 1 |
| Author: | TimB [ Mon Aug 15, 2005 9:48 am ] |
| Post subject: | How do I know if I have a blown head gasket? |
Anybody tell me ways of checking for blown head gasket or valve wear. |
|
| Author: | 13secmini [ Mon Aug 15, 2005 10:01 am ] |
| Post subject: | |
you can grab a cheap engine compression gauge from supercheap and see if all cylinders have similar compression. Just take a plug out, stick it in and turn the motor over a couple of revolutions. |
|
| Author: | TimB [ Mon Aug 15, 2005 10:11 am ] |
| Post subject: | |
Thanks! Can you answer any of my other qestions? See recent posts. |
|
| Author: | marcsvenson [ Mon Aug 15, 2005 11:20 am ] |
| Post subject: | |
as said above or check for bubbles in the water when the engines running and check under your oil cap for whitish milky stuff |
|
| Author: | TimB [ Mon Aug 15, 2005 11:41 am ] |
| Post subject: | |
There's no milky stuff anywhere just oil and water where it should be. I'll check for bubbles though. My other questions are in seperate posts in the mini mod index. I thought I was being smart by not putting too many questions in the one post. Cheers |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|