Ausmini
It is currently Sat Jul 05, 2025 11:12 pm

Board index » Mini Chat » Mini & A/A+ Series Mods

All times are UTC + 10 hours




Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
smac
 Post subject: Knuckle joint shank size
PostPosted: Fri Feb 16, 2007 9:03 am 
Offline
1098cc
1098cc
User avatar

Joined: Fri Aug 26, 2005 1:03 pm
Posts: 1540
Location: Napier, NZ
I'm going to look at packing out the rear knuckle joints with washers until I can get my hands on some adjustable trumpets. Does anyone know the size of the knuckle joint shank (that goes into the trumpet), and therefore the ID of the washers I need? Engineers will prolly be closed by the time I get them out tomorrow.
Top
 Profile  
 
drmini in aust
 Post subject:
PostPosted: Fri Feb 16, 2007 3:49 pm 
Offline
religious status
religious status
User avatar

Joined: Fri Mar 19, 2004 6:19 pm
Posts: 39752
Location: near Baulkham Hills, NSW
Pretty sure they are 0.500" (12.7mm) for stockers, the MiniSport Adjustarides are bigger just to make life difficult.... :wink:

_________________
DrMini- 1970 wasaMatic 1360, Mk1S crank, 86.6HP (ATW) =~125 @ crank, 45 Dellorto (38 chokes), RE282 sprint cam, 1.5 rockers, 11.0:1 C/R. :mrgreen:
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » Mini Chat » Mini & A/A+ Series Mods

All times are UTC + 10 hours


Who is online

Users browsing this forum: No registered users and 3 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  

© 2016 Ausmini. All garage work involves equal measures of enthusiasm, ingenuity and a fair degree of irresponsibility.