| ausmini https://ausmini.com/forums/ |
|
| The new GE https://ausmini.com/forums/viewtopic.php?f=4&t=3503 |
Page 1 of 1 |
| Author: | Namibian CAMEL [ Fri Dec 17, 2004 2:57 pm ] |
| Post subject: | The new GE |
mini 
I am a wally. It is worse than what it looks I just got owned to the tune of 200 hard earned Bucks The guy is laughing Oh well it goes good apparently, when i put a new clutch in it. Any hints. And the rust hole. How to fix? Surely something this bad has been fixed before Its 1977 TC and its a real shitbox to put it politley. Demo derby car here i come Win a Grand, and make a profit |
|
| Author: | Namibian CAMEL [ Sun Dec 19, 2004 7:42 pm ] |
| Post subject: | |
So i had the gemmy started today. The mini batt got it to work. And i set to putting the foot down and making the engine work. It was so noisy and sounded extra sweet  , it was great. The clutch is blown in it so it wont drive - but if the accelrator is flat to the floor the vehicle will move a few centimetres. 
At least i know i can sell the engine for 50 bucks - it goes well. 
|
|
| Author: | gafmo [ Sun Dec 19, 2004 11:00 pm ] |
| Post subject: | |
Were the F is that Hole 
|
|
| Author: | Namibian CAMEL [ Mon Dec 20, 2004 7:36 pm ] |
| Post subject: | |
That hole is the left side of the boot. But the whole boot is pretty well gone too. a friend gave me a super idea and i am going to have to go with it. Im going to cut the boot end off, the back end where the rust is, and weld some of that corrigated iron sheeting over the back of it. I think that will be funny.
|
|
| Author: | Mr G [ Mon Jan 17, 2005 10:03 am ] |
| Post subject: | |
wow! that lloks like it might have had a bath at some stage (?) Pity. car looked pretty clean other than that. options: put the carpet back and pretend you don't know about it.
fix it...... 
paddock thrash it  looks like you've got some good paddocks.
|
|
| Author: | Namibian CAMEL [ Mon Jan 17, 2005 7:19 pm ] |
| Post subject: | |
ohh so i just reaslied that this section of the forum is about the new MINI, not just a new mini 
|
|
| Author: | Mr G [ Tue Jan 18, 2005 1:47 pm ] |
| Post subject: | |
it did take some thinking about.  , but then I got it.
you've bought a new GE-mini.
|
|
| Author: | Namibian CAMEL [ Fri Jan 21, 2005 8:38 pm ] |
| Post subject: | |
There never was any doubt that the GE was going to be a paddock basher, save the mini from being hammered in the paddock , And it does get a hammering  .
Well the car has been up on ramps for weeks waiting for me and mates, if/when they come around, to hack at the clutch and try to shove another one in it. So that will be fun
|
|
| Author: | Namibian CAMEL [ Sat Feb 26, 2005 9:37 pm ] |
| Post subject: | |
Took to the gemini with a spanner . didnt know what i was doing. I just pulled poked screwed bashed anything that looked like it needed pulling poking crewing or bashing. I took all the bolts out around near the engine near the clutch place, and then i did all the bolts around near the gearbox, seeing if i could just plonk it out!  But it didnt go, So tomorrow i will need to give it a bashin so it will fall out
|
|
| Author: | Dylans Clubby [ Tue Mar 01, 2005 12:05 pm ] |
| Post subject: | |
Namibian CAMEL wrote: ohh
so i just reaslied that this section of the forum is about the new MINI, not just a new mini nice one mate |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|