ausmini
https://ausmini.com/forums/

1415cc stroker 8V Bimmer Twinky
https://ausmini.com/forums/viewtopic.php?f=23&t=94599		 Page 1 of 1
Author:  TheMiniMan [ Sun Jan 08, 2017 12:57 pm ]
Post subject:  1415cc stroker 8V Bimmer Twinky
This donk is for my mums old red/white/blue ratty station wagon

1415cc, 73mm bore 84mm crank, Ground offset & hardened & balanced
JP pistons (lopped tops off) 11.5:1 comp ratio,
Ported & flowed Cyl head with cams ground to suit,
ARP rod bolts "S" rods re-sized & narrowed to suit stroker crank
Light flywheel, orange clutch, AP plate
overhauld 4sync remote box with Quaife LSD
lots of goodies but lots of stock stuff too

we are just running the single SU carb ATM so we can check for oil & water leaks
before fitting the whole thing into the car,
-->once its in the car we will inject with Adaptronic ECU & all the sensors & triggers &
relays & high pressure fuel pump etc

Image

Image

Image

Image

Image

Image

Video of it running on the bench/drum here

https://www.youtube.com/watch?v=xCn2zV6-x9w

should be a little beauty (hopefully) can`t wait to shove it in & tune the little girl
hangin for a fangin :-)
Happy New year everyone
Matt
Author:  Kennomini [ Mon Jan 09, 2017 7:41 pm ]
Post subject:  Re: 1415cc stroker 8V Bimmer Twinky
Looks great Matt.
Question: why 8 valve and not 16?
Author:  TheMiniMan [ Sat Jan 14, 2017 9:06 am ]
Post subject:  Re: 1415cc stroker 8V Bimmer Twinky
Cheaper :-)

Also we had a spare 8v cyl head sitting here,
had the stroker crank just sitting here,
had a spare 73mm Bimmer-modified block just sitting here
had the old 4-sync g/box from mums car,,, basically we had it all just sitting here

& we wanted to test out our new single SU manifold

& we wanted to test out our new 8v cam-grind

so,,, it was simply a matter of "Because we can" :-)

it`s also a learning curve,,, we all need to keep learning i reckon
learn something every day or it is a waste of the day
Author:  TheMiniMan [ Wed Jan 25, 2017 9:46 am ]
Post subject:  Re: 1415cc stroker 8V Bimmer Twinky
we finally got some more time to throw this little fella into the hole & get him running
runs sweet as a nut & smooth as a baby`s bottom :-)

at some stage within the next few weeks we will throw all the injection stuff at it,
& run him up on the dyno
can`t wait :-)
Image

cheers people
Matt
Author:  9YaTaH [ Wed Jan 25, 2017 11:05 am ]
Post subject:  Re: 1415cc stroker 8V Bimmer Twinky
Terrific stuff Matty 8)
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/