ausmini
https://ausmini.com/forums/

Vtec In Clubman?
https://ausmini.com/forums/viewtopic.php?f=23&t=20227		 Page 1 of 1
Author:  Bryant [ Fri Jun 16, 2006 9:33 pm ]
Post subject:  Vtec In Clubman?
I was wondering if it was possible to put a vtec 1800cc in a clubman? does anyone know how much it would set me back to do this? where bouts can you get vtecs from in aus?
cheers
andrew
Author:  gzeVan [ Fri Jun 16, 2006 9:42 pm ]
Post subject: 
yes it is possible there are a few kits overseas or you can fabricate one yourself look in the conversion links and you will find some pages that might help
most jap engine importers may have them or can arrange one for the cost and hassel its probably easier to get a b16 vtec
Author:  Vtec mini [ Sat Jun 17, 2006 7:01 pm ]
Post subject: 
Yes, the B18c vtec is about 6mm higher than the B16.
Author:  miniboy1962 [ Sun Jun 18, 2006 1:10 pm ]
Post subject: 
And about 2 grand more expensive...
Author:  Minute [ Sun Jun 18, 2006 2:29 pm ]
Post subject: 
Quote:
And about 2 grand more expensive...


only 2 grand?!? i spose depends on where u r in aus...every honda wrecker in WA cant get their hands on one.. and if they did they wanted $7,500 instead of $2,500 for a b16a[/quote]
Author:  Vtec mini [ Sun Jun 18, 2006 4:48 pm ]
Post subject: 
I'm glad vtec engines are a lot cheaper in NZ, I would not like to pay more then $4500 for a B18cR from trademe or privately. http://www.stronghonda.co.nz/vtec_kits.htm
CheersPaul.
Author:  miniboy1962 [ Sun Jun 18, 2006 5:44 pm ]
Post subject: 
I'd definitely go the B16a. Spend the extra 2 or more grand on it and you'll have an awesome engine. I think the B18 only has 30hp or something. Surely you could get that for 2 grand without all the hassles involved in fitting a massive engine into a tiny space. My little 1.3 only just fits.
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/