Hi

I'm looking for good cheap courior to to deliver a half cut from QLD to the ACT.
Anyone know of one??????

Thanks

Steven

I used to work at a transport depot in Goulburn and we handled a fair amount of car parts from a lot of different transport companies. There was one company that I know of that went from Queensland to Sydney and Sydney to Canberra. They were called Vella Transport.

Give them a call for a quote. You will probably need the measurements and the weight of the cut to get an accurate price.

thanks for that.

The guy im getting the front cut off just emailed me with a price, $300 i think sounds allright considering its coming from QLD

why don't you just wait for santa to deliver it, he's always free

_________________
-doing a Degree in Mechanical Engineering,
and a few conversions:
13B Extend in a 1600
4EFTE in a mini ute (all slowly)

Sunburst that's a good rate I got mine from Brissie and I think it was $450! Also where in Canberra are you if you need a hand give me a yell.

Cheers

Matt

_________________
225hp atw on 14psi. 1/4 Mile no idea. Take one 1971 Mini Clubman, one Starlet GT Halfcut, Simmer over a warm MIG Welder, and Voila Minstar! www.mpdesign.id.au

Hi matt

Thanks for the offer.

I'll just have to wait a little while untill i get some more $$$$$ to start on the subframe. The motor just went on my credit card , but i could'nt let this engine pass me by with such low km's and the Lsd

Oh and i live over in Ngunnawal.

Cheers

Steve

I'm in giralang, and as I say one day I'll do the 4efte conversion that's sitting in the garage

_________________
-doing a Degree in Mechanical Engineering,
and a few conversions:
13B Extend in a 1600
4EFTE in a mini ute (all slowly)

Hugh do you have the equipment to at least start on the subbie or is it a matter of being time poor due to Uni commitments?

_________________
225hp atw on 14psi. 1/4 Mile no idea. Take one 1971 Mini Clubman, one Starlet GT Halfcut, Simmer over a warm MIG Welder, and Voila Minstar! www.mpdesign.id.au

I have all the parts and everything to get going apart from often the biggest tool in the garage (me) yep, your pretty much right no time for me. And am meant to be finishing off somweone else's Rod that's in my garage first (some $$ in it for me)

_________________
-doing a Degree in Mechanical Engineering,
and a few conversions:
13B Extend in a 1600
4EFTE in a mini ute (all slowly)