Been a while since I've seen one, but I think it should fit nicely.
I would be taking some photos & measurements before buying a front cut though
| ausmini https://ausmini.com/forums/ |
|
| too big ? https://ausmini.com/forums/viewtopic.php?f=23&t=18560 |
Page 1 of 1 |
| Author: | _666_ [ Thu Apr 27, 2006 2:10 am ] |
| Post subject: | too big ? |
just a question easiest to ask you lot.. a Daihatsu Charade.. 1995.. 1.3 engine will it be too big for a roundnose. |
|
| Author: | awdmoke [ Thu Apr 27, 2006 4:00 am ] |
| Post subject: | |
Been a while since I've seen one, but I think it should fit nicely. I would be taking some photos & measurements before buying a front cut though
|
|
| Author: | sports850 [ Thu Apr 27, 2006 8:01 am ] |
| Post subject: | |
I know the 3 cylinder one litre fits neatly , don't know how much the extra cylinder adds to the length though . Go for a scrounge through a wreckers or used car yard with a tape measure , if it's only a slight difference then maybe , if it's a big difference then have another think about it . The 3 cylinder motor is quite a good motor and was available as a turbo twin cam as well , not really to be ignored . |
|
| Author: | gzeVan [ Thu Apr 27, 2006 8:30 am ] |
| Post subject: | |
the 1.3 motor will fit in a round nose i measured one up years ago when i did a N/A 4efe conversion i chose the 4efe over the daihatsu because it was a twin cam  yes I was young and thought everything had to be a twin cam to be good
|
|
| Author: | JC [ Thu Apr 27, 2006 9:28 am ] |
| Post subject: | |
The 4efe would be a good conversion. I'm driving my sister's starlet at the moment. It goes great. Would go even better in a mini! |
|
| Author: | _666_ [ Thu Apr 27, 2006 1:10 pm ] |
| Post subject: | |
hmm ok.. well ill have a good look into this..
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|