| ausmini https://ausmini.com/forums/ |
|
| Quick conrod question https://ausmini.com/forums/viewtopic.php?f=2&t=99919 |
Page 1 of 1 |
| Author: | ben23f [ Wed Apr 22, 2020 1:51 pm ] |
| Post subject: | Quick conrod question |
Hi All, Quick question, are the 998 and 1100 conrods the same (interchangeable as a set)? Thanks |
|
| Author: | Kennomini [ Wed Apr 22, 2020 2:32 pm ] |
| Post subject: | Re: Quick conrod question |
Different stroke but YES they are interchangeable. I'm not sure about all the bearings..... And I believe the pistons and rods are different (offsets only) so 998 (maybe rods) and pistons will not work with a 1098 crank but a complete 1098 assembly will fit in a 998 block. |
|
| Author: | TK [ Wed Apr 22, 2020 3:03 pm ] |
| Post subject: | Re: Quick conrod question |
Yeah Nah Bearings are the same. rods are the same, 998 and 1100 have different pistons and cranks. |
|
| Author: | timmy201 [ Wed Apr 22, 2020 3:06 pm ] |
| Post subject: | Re: Quick conrod question |
998/1098 conrods come as two pairs, make sure you get a matched set with the matching caps |
|
| Author: | ben23f [ Wed Apr 22, 2020 4:22 pm ] |
| Post subject: | Re: Quick conrod question |
Yep I've got an 1100 crank but it only came with 3 conrods... Guy i got it from lost the 4th. But currently running a 998. Thanks |
|
| Author: | drmini in aust [ Thu Apr 23, 2020 12:54 pm ] |
| Post subject: | Re: Quick conrod question |
There were some 998/1098 rods made by Repco (I think) that had no little end bush, they were interference fit like a 1275. Pretty rare here though. And gudgeon pin was bigger. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|