| ausmini https://ausmini.com/forums/ |
|
| Cam timing https://ausmini.com/forums/viewtopic.php?f=2&t=99905 |
Page 1 of 1 |
| Author: | kiwiinwgtn [ Sat Apr 18, 2020 9:47 pm ] |
| Post subject: | Cam timing |
Looking for confirmation that for every 0.005 thou you move the cam gear you can advance or retard a cam by one degree. Can any one confirm the maths. Thanks Kiwiinwgtn |
|
| Author: | drmini in aust [ Sun Apr 19, 2020 10:55 am ] |
| Post subject: | Re: Cam timing |
PM sent. I measured a 9° (at crank) minispares offset cam key which is 4.5° actual at cam. Clamped down, the offset gap measured 0.034" using feeler gauges. = 0.0075555555" per cam degree. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|