| ausmini https://ausmini.com/forums/ |
|
| 1978 Brake lines https://ausmini.com/forums/viewtopic.php?f=2&t=99323 |
Page 1 of 1 |
| Author: | TK [ Mon Sep 16, 2019 8:00 pm ] |
| Post subject: | 1978 Brake lines |
Ok so I've had the brakes rebuilt and I'm putting it all back together but the lines from the dual line master cylinder to the valve thingy are a pain in the arse. I have ordered both lines from two different online Australian mini stores and both times the ones that they sent are wrong. It appears that the brake line ends that go into the valve thingy are metric? Is that correct? EDIT October 1978. |
|
| Author: | justfanginaround [ Tue Sep 17, 2019 7:41 am ] |
| Post subject: | Re: 1978 Brake lines |
yes metric on the valve block end with a 10mm hex, imperial on the other end with a 7/16 hex. |
|
| Author: | slacko [ Tue Sep 17, 2019 11:01 am ] |
| Post subject: | Re: 1978 Brake lines |
Metric both ends |
|
| Author: | TK [ Tue Sep 17, 2019 4:33 pm ] |
| Post subject: | Re: 1978 Brake lines |
FFS!!!! which is it? |
|
| Author: | slacko [ Tue Sep 17, 2019 5:11 pm ] |
| Post subject: | Re: 1978 Brake lines |
Australian dual system master cylinders are metric 10mm the 5 port pressure regulator valve are metric 10mm GMC227 dual system master cylinders are metric 1x10mm +1x12mm all other fittings are imperial 3/8 unf x 24tpi |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|