| ausmini https://ausmini.com/forums/ |
|
| Thickness of 7.5 inch Rotors https://ausmini.com/forums/viewtopic.php?f=2&t=98791 |
Page 1 of 1 |
| Author: | slide [ Mon Jul 15, 2019 4:19 pm ] |
| Post subject: | Thickness of 7.5 inch Rotors |
Does anyone know the minimum thickness at which 7.5 inch disc brake rotors can still be machined? Is it stamped on the rotor somewhere? I had some idea it was 10mm less than the new thickness which I seem to recall was around 6 mm. If I need new rotors which supplier is recommended? |
|
| Author: | slide [ Mon Jul 15, 2019 6:25 pm ] |
| Post subject: | Re: Thickness of 7.5 inch Rotors |
Sorry that should read 1mm undersize, not 10mm. |
|
| Author: | drmini in aust [ Mon Jul 15, 2019 6:36 pm ] |
| Post subject: | Re: Thickness of 7.5 inch Rotors |
They are 3/8" new, minimum used to be 5/16" = 8mm. But so cheap new now they're not worth machining. |
|
| Author: | gtogreen1969 [ Mon Jul 15, 2019 6:51 pm ] |
| Post subject: | Re: Thickness of 7.5 inch Rotors |
These were from MKO and have MIN THK 8 MM stamped onto them. https://minikingdomonline.com.au/produc ... lubman-gt/ Only $25 Attachment: MIN THK 8 MM.jpg
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|