This clip
https://minikingdomonline.com.au/produc ... nnet-stay/
Earlier cars had the type below, but you can use the later type above on these too
| ausmini https://ausmini.com/forums/ |
|
| Bonnet stay https://ausmini.com/forums/viewtopic.php?f=2&t=98782 |
Page 1 of 1 |
| Author: | Asiemek [ Fri Jul 12, 2019 8:46 pm ] |
| Post subject: | Bonnet stay |
how is the bonnet stay fixed to the under side of the bonnet. Though there was a tab with a hole but my 65 deluxe is a bit different. is there a special clip? |
|
| Author: | i got a mini [ Fri Jul 12, 2019 9:22 pm ] |
| Post subject: | Re: Bonnet stay |
https://minikingdomonline.com.au/produc ... ay-rubber/ |
|
| Author: | Asiemek [ Sat Jul 13, 2019 8:41 am ] |
| Post subject: | Re: Bonnet stay |
i got a mini wrote: https://minikingdomonline.com.au/product/bonnet-stay-rubber/ nah the other end. |
|
| Author: | timmy201 [ Sat Jul 13, 2019 9:26 am ] |
| Post subject: | Re: Bonnet stay |
This clip https://minikingdomonline.com.au/produc ... nnet-stay/ Earlier cars had the type below, but you can use the later type above on these too
|
|
| Author: | Asiemek [ Sun Jul 14, 2019 7:35 pm ] |
| Post subject: | Re: Bonnet stay |
[quote="timmy201"]This clip https://minikingdomonline.com.au/produc ... nnet-stay/ Earlier cars had the type below, but you can use the later type above on these too [/quotethis is the bit that doesnt seem to work |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|