| ausmini https://ausmini.com/forums/ |
|
| Diagonal Tie Rod Washer position https://ausmini.com/forums/viewtopic.php?f=2&t=98653 |
Page 1 of 1 |
| Author: | GuamMini [ Thu Jun 06, 2019 8:39 am ] |
| Post subject: | Diagonal Tie Rod Washer position |
I am replacing my Diagonal Tie Rod bushings and would like to know how does the washer on the side where the nut goes is facing? it is not a flat washer but a washer the is curved or like a bowl shape. Which side is facing the bushing the closed or open side of the washer. Sorry this is the best I could explain it. I hope some of this picture helps.  This looks like there are two washers a flat one and a curved one? 
|
|
| Author: | cgo [ Thu Jun 06, 2019 11:40 am ] |
| Post subject: | Re: Diagonal Tie Rod Washer position |
20 is cup washer, concave face to bush 21 is flat washer Diagram only shows one bush of the two per side |
|
| Author: | GuamMini [ Thu Jun 06, 2019 11:54 am ] |
| Post subject: | Re: Diagonal Tie Rod Washer position |
cgo wrote: 20 is cup washer, concave face to bush 21 is flat washer Diagram only shows one bush of the two per side Thank you no wonder they also sell the flat one, thanks |
|
| Author: | 1071 S [ Thu Jun 06, 2019 6:50 pm ] |
| Post subject: | Re: Diagonal Tie Rod Washer position |
Looks like you have the "correct" pairing of one poly bush with one rubber version. Don't forget to put the poly item at the front.... Cheers, Ian |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|