| ausmini https://ausmini.com/forums/ |
|
| Hydrolastic Pressure https://ausmini.com/forums/viewtopic.php?f=2&t=98408 |
Page 1 of 1 |
| Author: | IndigoBlueCooperS [ Sat Mar 30, 2019 11:25 am ] |
| Post subject: | Hydrolastic Pressure |
Hi All, What is a good pressure for when the car is off the ground? That is, a normal pressure of 275 PSI on the ground is equivalent to ??? with all four wheels of the ground? I want to set it so that I have some chance of it being around the mark when I lower the car to the ground. That is, I will have some chance of a reasonable ride height which will obviously need some fine tuning once settled. Thanks |
|
| Author: | Bill B [ Sat Mar 30, 2019 2:41 pm ] |
| Post subject: | Re: Hydrolastic Pressure |
Can't remember actual numbers but guess at around 230-240psi. It isn't a huge difference. |
|
| Author: | 9YaTaH [ Sun Mar 31, 2019 8:33 am ] |
| Post subject: | Re: Hydrolastic Pressure |
The technique is to pump to 300 PSI (even a little over)...drive it around for a couple of days till it all settles down...then adjust ride height to your liking... [Edit: usually after disassembly/reassembly] |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|