ausmini
https://ausmini.com/forums/

Tin brake master cylinders
https://ausmini.com/forums/viewtopic.php?f=2&t=98406		 Page 1 of 1
Author:  simonw [ Thu Mar 28, 2019 5:24 pm ]
Post subject:  Tin brake master cylinders
Image

I’m sorry but these new Uk replacements are just not pretty ....


Sent from my iPhone using Tapatalk
Author:  i got a mini [ Thu Mar 28, 2019 7:10 pm ]
Post subject:  Re: Tin brake master cylinders
i brought some for my project and the quality was amazing maybe u just got a bad one as that one does not look pretty at all. i would be contacting the supplier
Author:  Irish Yobbo [ Fri Mar 29, 2019 7:50 am ]
Post subject:  Re: Tin brake master cylinders
'Just not pretty' is not how I'd describe it. 'Cheap, shoddy construction' is more like it.

I usually don't car how parts look, I care about how well they work. But you can look at that and see how poor the seams and welds are on that. It just looks like it's been manufactured as cheap as possible - not something I'd want to use for my brakes.
Author:  kiwiinwgtn [ Sat Apr 06, 2019 2:52 pm ]
Post subject:  Re: Tin brake master cylinders
Are the push rods the same length as your original one. I reckon they have shorten them by 6mm. Havnt got an old one to check against at my end. Ta Bernard

Sent from my SM-J530Y using Tapatalk
Author:  TartanRed [ Sun Apr 07, 2019 9:07 pm ]
Post subject:  Re: Tin brake master cylinders
I had to buy a new tin clutch MC for my 850 and I think I got it thru Minispares in the UK. It wasn't quite as nicely made as the originals (the seams were a bit thicker etc), but it was good quality - certainly looks an awful lot better than the one in your picture. That looks like a knock-off or a bad second... I would be sending it back mate...
Author:  simonw [ Sun Apr 07, 2019 9:38 pm ]
Post subject:  Re: Tin brake master cylinders
Thanks guys ... it does look like a lemon .


Sent from my iPhone using Tapatalk
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/