| ausmini https://ausmini.com/forums/ |
|
| Coolant temp sender question https://ausmini.com/forums/viewtopic.php?f=2&t=98381 |
Page 1 of 1 |
| Author: | Silobin [ Wed Mar 20, 2019 9:38 pm ] |
| Post subject: | Coolant temp sender question |
Hi chaps, hoping someone can tell me if the sender to suit an electronic temp gauge (fitted in the head casting near the thermostat) needs a copper washer or sensor sealant? It’s NOT a tapered thread on the sensor. cheers, Silas |
|
| Author: | drmini in aust [ Wed Mar 20, 2019 10:13 pm ] |
| Post subject: | Re: Coolant temp sender question |
No. Just screw it in, it seats on a tapered face in the head. |
|
| Author: | Irish Yobbo [ Thu Mar 21, 2019 7:36 am ] |
| Post subject: | Re: Coolant temp sender question |
A low strength thread sealant helps if you have any leaks there. I use a low-strength thread sealant in most cases just to be sure. |
|
| Author: | Silobin [ Thu Mar 21, 2019 7:39 am ] |
| Post subject: | Re: Coolant temp sender question |
Brilliant, Thanks doc! |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|