| ausmini https://ausmini.com/forums/ |
|
| Radiator identification https://ausmini.com/forums/viewtopic.php?f=2&t=98139 |
Page 1 of 1 |
| Author: | carter [ Tue Jan 08, 2019 8:19 pm ] |
| Post subject: | Radiator identification |
Hey I have done a search and cannot find information on it...... my question is what is the number suppose to be that is on the brass plate soldered onto the radiator suppose to be for a mk -1 1967 cooper s? Cheers |
|
| Author: | simon k [ Tue Jan 08, 2019 8:53 pm ] |
| Post subject: | Re: Radiator identification |
you mean the little plate that was soldered on to the fins that's never there because it falls off? |
|
| Author: | carter [ Tue Jan 08, 2019 9:03 pm ] |
| Post subject: | Re: Radiator identification |
Usually soldered onto the top tank..... I have a few that are different numbers. But yea that’s the one I’m talking about . |
|
| Author: | winabbey [ Tue Jan 08, 2019 9:07 pm ] |
| Post subject: | Re: Radiator identification |
Cooper S radiator is AYA2077 Attachment: PUB1012 C02-1 R.jpg Attachment: AYA2077 Radiator a.jpg
|
|
| Author: | carter [ Wed Jan 09, 2019 4:53 pm ] |
| Post subject: | Re: Radiator identification |
That’s what I was after! Thank you very much |
|
| Author: | TOZOOM [ Thu Jan 10, 2019 12:22 pm ] |
| Post subject: | Re: Radiator identification |
If the plate is soldered to the top tank near the pipe its a early 850 / cooper if its near the cap like Winabbey has shown its for the later models. And both tanks are different to each other. |
|
| Author: | simon k [ Fri Jan 11, 2019 10:35 am ] |
| Post subject: | Re: Radiator identification |
I was actually thinking of this plate (looking at it, I think it's a piece of brass feeler gauge anyway) Attachment: 20190111_112631.jpg but I had it confused with this plate (from the same radiator) Attachment: 20190111_112717.jpg it's probably from being reconditioned or recored at some point. I think this is the radiator that was on my S I have a radiator with one of the plates Doug showed, I'd take a picture of that too but it seems like it's a structural member in my tower of radiators and I couldn't get it out |
|
| Author: | phillb [ Fri Jan 11, 2019 11:17 am ] |
| Post subject: | Radiator identification |
I still have the Newcell label still on my radiator but it’s quite unusual for them to still be there because any time the radiator would be cleaned out or repaired they heat up the top tank and it would just fall off and be thrown away. Most radiator shops wouldn’t be bothered trying to solder it back on. Sent from my iPhone using Tapatalk |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|