| ausmini https://ausmini.com/forums/ |
|
| Lockheed Master Pushrod https://ausmini.com/forums/viewtopic.php?f=2&t=98095 |
Page 1 of 1 |
| Author: | phillb [ Wed Dec 26, 2018 10:12 am ] |
| Post subject: | Lockheed Master Pushrod |
I currently have my clutch system apart and want to replace the clevis pins ect. I want to also replace the clutch master pushrod because I’m sure the holes in the fork are worn oval. However I can’t seem to find them as a seperate part on any of the usual Mini Suppliers? Sent from my iPad using Tapatalk |
|
| Author: | drmini in aust [ Wed Dec 26, 2018 10:53 am ] |
| Post subject: | Re: Lockheed Master Pushrod |
Not seen them for years. Most people weld the pin holes and redrill. Even back in the 70s. |
|
| Author: | winabbey [ Wed Dec 26, 2018 11:22 am ] |
| Post subject: | Re: Lockheed Master Pushrod |
In case it helps the BMC part number is 17H7557 and Lockheed 92021. |
|
| Author: | fuzzy-hair-man [ Wed Dec 26, 2018 11:46 am ] |
| Post subject: | Re: Lockheed Master Pushrod |
A while ago I rang up AP Racing Australia as a Australian division of AP, they said they can still get a lot of the Lockheed brake stuff for minis. It might be worth a look? https://www.apracing.com/ |
|
| Author: | TOZOOM [ Thu Dec 27, 2018 6:34 am ] |
| Post subject: | Re: Lockheed Master Pushrod |
Hi Phillb I have both types of clevis that have been welded. 1 for the tin can and for the plastic reservoir types. so if you get stuck let me know and you can have one. Rob D |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|