ausmini
https://ausmini.com/forums/

morris cooper badge on boot
https://ausmini.com/forums/viewtopic.php?f=2&t=97561		 Page 1 of 1
Author:  p7676 [ Mon Jul 30, 2018 7:21 pm ]
Post subject:  morris cooper badge on boot
Hello All ,I have just bought the badge from MK The holes in the badge are parallel unfortunately the boot holes are different the 2 Centre holes are 3.5 mm lower than the 2 outside holes.1970 C,S common problem ?
Allen
Author:  gtogreen1969 [ Mon Jul 30, 2018 8:26 pm ]
Post subject:  Re: morris cooper badge on boot
The 4 boot holes should be on the same line.

Here is a drawing from Winabbeys collection.

Attachment:
Morris Cooper Boot badge holes (2).jpg

Attachment:
Boot badge holes.jpg




A few boot pics here - viewtopic.php?f=2&t=38758
Author:  simon k [ Mon Jul 30, 2018 9:19 pm ]
Post subject:  Re: morris cooper badge on boot
p7676 wrote:
Hello All ,I have just bought the badge from MK The holes in the badge are parallel unfortunately the boot holes are different the 2 Centre holes are 3.5 mm lower than the 2 outside holes.1970 C,S common problem ?
Allen


no Allen, sorry, not a common problem - the holes are all on the same horizontal plane
Author:  p7676 [ Mon Jul 30, 2018 9:38 pm ]
Post subject:  Re: morris cooper badge on boot
guess I will have to do some mods, the old badge had the Centre studs ground off Strange the holes are an accurate width but not height.
Allen
Author:  simon k [ Mon Jul 30, 2018 9:56 pm ]
Post subject:  Re: morris cooper badge on boot
are the screw holes for the boot lid liner there on the inside?
Author:  Scoop [ Mon Jul 30, 2018 10:33 pm ]
Post subject:  Re: morris cooper badge on boot
simon k wrote:
are the screw holes for the boot lid liner there on the inside?

I was thinking that too :idea:
Author:  p7676 [ Tue Jul 31, 2018 9:40 pm ]
Post subject:  Re: morris cooper badge on boot
screw holes are there on the inside
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/