No. But I've run a lot of performance cams in road Minis since 1964.
| ausmini https://ausmini.com/forums/ |
|
| Camshaft 621 1/2" Lobe No Rings https://ausmini.com/forums/viewtopic.php?f=2&t=97223 |
Page 1 of 1 |
| Author: | cooperess [ Thu May 17, 2018 11:27 am ] |
| Post subject: | Camshaft 621 1/2" Lobe No Rings |
I have the above, it appears to be from a Mini with a fuel pump lobe and star drive. Can anyone tell me more? |
|
| Author: | drmini in aust [ Thu May 17, 2018 12:29 pm ] |
| Post subject: | Re: Camshaft 621 1/2" Lobe No Rings |
621 is a camtech number. They are in chipping Norton NSW. Timing 25-56/65-20. Duration 261 inlet 265 exhaust. Cam lobe lift 0.264"/0.266" LCA 108° Rocker clearance .015". I had one, GR's RE266SS goes a lot harder. |
|
| Author: | Convertible Mini [ Sat May 19, 2018 7:44 pm ] |
| Post subject: | Re: Camshaft 621 1/2" Lobe No Rings |
Does GR pay you to hype his Cams and stuff? lol. |
|
| Author: | drmini in aust [ Sat May 19, 2018 7:56 pm ] |
| Post subject: | Re: Camshaft 621 1/2" Lobe No Rings |
No. But I've run a lot of performance cams in road Minis since 1964.
|
|
| Author: | Ian_B [ Sun May 20, 2018 9:17 pm ] |
| Post subject: | Re: Camshaft 621 1/2" Lobe No Rings |
Good on Graham for Aussie development and not selling rubbish to make money like a bolt last week Weak as |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|