| ausmini https://ausmini.com/forums/ |
|
| Cutting high tensile studs https://ausmini.com/forums/viewtopic.php?f=2&t=97032 |
Page 1 of 1 |
| Author: | Ian_B [ Mon Mar 26, 2018 8:22 pm ] |
| Post subject: | Cutting high tensile studs |
I need to shorten some Maintaining tensile is important. Have cutting disc in 4 inch grinder .Hand hacksaw .Power hacksaw .Lathe .Spray bottle full of water Any ideas Gentlemen. |
|
| Author: | peterb [ Tue Mar 27, 2018 5:35 am ] |
| Post subject: | Re: Cutting high tensile studs |
Power hacksaw and cooling if required. |
|
| Author: | drmini in aust [ Tue Mar 27, 2018 6:10 am ] |
| Post subject: | Re: Cutting high tensile studs |
1mm thick cutting disc. Will cut through before stud gets hot enough to alter temper. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|