I'd been thinking about making 1 of these for a while now after discussions from others on here , and
low and behold if a mate didn't turn up with 1 for me , he decided to get 2 made when he made his ,
i was over the moon
.
| ausmini https://ausmini.com/forums/ |
|
| Great Xmas Present https://ausmini.com/forums/viewtopic.php?f=2&t=96516 |
Page 1 of 1 |
| Author: | goodie [ Mon Dec 25, 2017 7:18 am ] |
| Post subject: | Great Xmas Present |
I'd been thinking about making 1 of these for a while now after discussions from others on here , and low and behold if a mate didn't turn up with 1 for me , he decided to get 2 made when he made his , i was over the moon .
|
|
| Author: | ianscampbell [ Mon Dec 25, 2017 10:53 am ] |
| Post subject: | Re: Great Xmas Present |
These are great! Just so easy to lift the front without any damage. |
|
| Author: | John Sneddon [ Tue Dec 26, 2017 4:36 pm ] |
| Post subject: | Re: Great Xmas Present |
I got one of these for my birthday just before Christmas - should be in all good tool boxes |
|
| Author: | mickmini [ Wed Dec 27, 2017 10:59 am ] |
| Post subject: | Re: Great Xmas Present |
good one! amazing that the BMC engineers knew what they were doing when they designed it! |
|
| Author: | stewartp [ Sun Dec 31, 2017 6:25 pm ] |
| Post subject: | Re: Great Xmas Present |
Exscuse my ignorance but what is it? Also if it is useful can someone give me dimensions? |
|
| Author: | gtogreen1969 [ Sun Dec 31, 2017 6:50 pm ] |
| Post subject: | Re: Great Xmas Present |
stewartp wrote: Exscuse my ignorance but what is it? Also if it is useful can someone give me dimensions? Its a jacking block for the front end. The dimensions are in the how to section or in most mini manualsviewtopic.php?t=78195 |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|