| ausmini https://ausmini.com/forums/ |
|
| Door Hinge ID https://ausmini.com/forums/viewtopic.php?f=2&t=96085 |
Page 1 of 1 |
| Author: | cooperess [ Mon Sep 25, 2017 9:55 am ] |
| Post subject: | Door Hinge ID |
Attachment: Mini Door Hinge ID.jpg I am wondering how to identify the door hinge marking so I know where each one goes.The picture shows marking but I don't know the codes. |
|
| Author: | Timbo [ Mon Sep 25, 2017 2:18 pm ] |
| Post subject: | Re: Door Hinge ID |
I think its 1 & 2 upper right. 3 & 4 upper left, 5 & 6 lower right, 7 & 8 lower left. That looks like a lower left, you can tell from the angle. The upper ones have much more angle on them than the lower ones and the lower ones angle in a the the bottom whereas the upper slope in at the top. Tim |
|
| Author: | winabbey [ Mon Sep 25, 2017 4:20 pm ] |
| Post subject: | Re: Door Hinge ID |
There's a couple of previous posts about this topic. viewtopic.php?f=2&t=22512 viewtopic.php?f=2&t=86482 |
|
| Author: | Silobin [ Wed Sep 27, 2017 2:02 pm ] |
| Post subject: | Re: Door Hinge ID |
Timbo wrote: I think its 1 & 2 upper right. 3 & 4 upper left, 5 & 6 lower right, 7 & 8 lower left. That looks like a lower left, you can tell from the angle. The upper ones have much more angle on them than the lower ones and the lower ones angle in a the the bottom whereas the upper slope in at the top. Tim This is correct, I labeled mine at diss assembly. Silas |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|