| ausmini https://ausmini.com/forums/ |
|
| Torque wrench in Coffs Harbour https://ausmini.com/forums/viewtopic.php?f=2&t=95619 |
Page 1 of 1 |
| Author: | Buznout [ Thu Jun 22, 2017 11:30 am ] |
| Post subject: | Torque wrench in Coffs Harbour |
Hi all, Am curious if anyone on here is in Coffs Harbour and has a torque wrench that will nip up the hub nuts to 260NM? Am intending to buy one next week but as there is a car show on Sunday (25th June) I was hoping to make, I thought that I would ask. |
|
| Author: | DavidE [ Thu Jun 22, 2017 12:52 pm ] |
| Post subject: | Re: Torque wrench in Coffs Harbour |
Buznout wrote: Hi all, Am curious if anyone on here is in Coffs Harbour and has a torque wrench that will nip up the hub nuts to 260NM? Am intending to buy one next week but as there is a car show on Sunday (25th June) I was hoping to make, I thought that I would ask. Nip them up snug and drive to your friendly tyre shop. They might have one. |
|
| Author: | Buznout [ Thu Jun 22, 2017 12:58 pm ] |
| Post subject: | Re: Torque wrench in Coffs Harbour |
Thanks for the reply. Had thought about trying to get them tight (install split pins) then drive somewhere but wasn't sure it was all that safe. Also I am in the middle of a 100kph zone to make it just that extra bit hairy... |
|
| Author: | simon k [ Thu Jun 22, 2017 4:05 pm ] |
| Post subject: | Re: Torque wrench in Coffs Harbour |
do them up really really f*cking tight using a pipe over the end of your breaker bar, then do them up a bit more until the split pin lines up |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|