I know. I know.
I have tried but I can't see anything.
Anyway here are some pics for the wise ones.
Can someone enlighten me?
Sent from my iPhone using Tapatalk
| ausmini https://ausmini.com/forums/ |
|
| Cylinder head no markings https://ausmini.com/forums/viewtopic.php?f=2&t=95590 |
Page 1 of 1 |
| Author: | schmoogene1 [ Sat Jun 17, 2017 10:23 am ] |
| Post subject: | Cylinder head no markings |
I know. I know. I have tried but I can't see anything. Anyway here are some pics for the wise ones. Can someone enlighten me? Sent from my iPhone using Tapatalk |
|
| Author: | mini210 [ Sat Jun 17, 2017 10:30 am ] |
| Post subject: | Re: Cylinder head no markings |
Whats the engine number stamped on the block and what mini is the engine out of? |
|
| Author: | schmoogene1 [ Sat Jun 17, 2017 10:45 am ] |
| Post subject: | Re: Cylinder head no markings |
Engine number is 9YA/TA/H 34286. This engine comes out of a deluxe, but it doesn't match the original compliance plate details. It has been converted to run on unleaded petrol. ( well that's what I was told and was running) Sent from my iPhone using Tapatalk |
|
| Author: | schmoogene1 [ Sat Jun 17, 2017 10:48 am ] |
| Post subject: | Re: Cylinder head no markings |
The markings from the first pic read "ECAM 4004" Sent from my iPhone using Tapatalk |
|
| Author: | schmoogene1 [ Sat Jun 17, 2017 11:41 am ] |
| Post subject: | Re: Cylinder head no markings |
Sorry. Just googled ECAM 4004 and answered my own question. ECAM 4004 is a pollution/smog head for the 998. Time to find something better. Sent from my iPhone using Tapatalk |
|
| Author: | drmini in aust [ Sat Jun 17, 2017 2:02 pm ] |
| Post subject: | Re: Cylinder head no markings |
They port as well as a 202 head does, just more Detroit Wonder Metal needs to be removed. 
|
|
| Author: | minimans [ Sat Jun 17, 2017 4:03 pm ] |
| Post subject: | Re: Cylinder head no markings |
Why does it have bolts and not studs to hold it down.................... |
|
| Author: | sitnlo62 [ Sat Jun 17, 2017 4:16 pm ] |
| Post subject: | Re: Cylinder head no markings |
minimans wrote: Why does it have bolts and not studs to hold it down.................... Because that was all BMC deemed necessary to do the job, and for that engine and state of tune they are correct. |
|
| Author: | minimans [ Sat Jun 17, 2017 7:11 pm ] |
| Post subject: | Re: Cylinder head no markings |
Your Aussie cars are so different in many aspects! I've never seen an A series that uses bolts before................ |
|
| Author: | drmini in aust [ Sat Jun 17, 2017 7:15 pm ] |
| Post subject: | Re: Cylinder head no markings |
These particular Australian head bolts are prone to snap from old age. I prefer to fit studs and nuts. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|