| ausmini https://ausmini.com/forums/ |
|
| Badge on A pillar https://ausmini.com/forums/viewtopic.php?f=2&t=95577 |
Page 1 of 1 |
| Author: | AWOODY [ Thu Jun 15, 2017 4:36 pm ] |
| Post subject: | Badge on A pillar |
Can someone tell me the correct position for the little badge that goes on the A pillar 71 or 72 mini . |
|
| Author: | MiniBrad [ Thu Jun 15, 2017 6:28 pm ] |
| Post subject: | Re: Badge on A pillar |
The 'British Leyland' badge on my Clubman is about 40mm (lower hole) 65mm (upper hole) above the bottom door hinge holes & 55mm forward of the door jam edge. These measurements are taken from the LHS because I cannot get to the RHS to compare. Brad |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|