You could also get iy resleeved in stainless steel
| ausmini https://ausmini.com/forums/ |
|
| Master cylinder rebuild https://ausmini.com/forums/viewtopic.php?f=2&t=95441 |
Page 1 of 1 |
| Author: | 8700s14 [ Mon May 22, 2017 10:10 pm ] |
| Post subject: | Master cylinder rebuild |
Hey all, just chasing opinions on a bit of pitting in a master cylinder. I gave it a quick hone and the only bit of corrosion that didn't come out is as pictured. I can't feel it when I rub my finger on it, but just don't know if I should proceed with a rebuild or should expect it would be doomed for failure? |
|
| Author: | 1071 S [ Mon May 22, 2017 10:41 pm ] |
| Post subject: | Re: Master cylinder rebuild |
The worst that can happen is that you may find it leaks a bit once you get it back together... it won't suddenly fail. If you can't face doing it twice then get a new one. Otherwise give it a go... if you can't feel any roughness then I would be optimistic. Cheers, Ian |
|
| Author: | gtogreen1969 [ Mon May 22, 2017 10:49 pm ] |
| Post subject: | Re: Master cylinder rebuild |
The first seal starts a long way down the bore. Just measure the depth from the circlip groove to the seal. |
|
| Author: | cooperess [ Tue May 23, 2017 11:13 am ] |
| Post subject: | Re: Master cylinder rebuild |
You could also get iy resleeved in stainless steel
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|