| ausmini https://ausmini.com/forums/ |
|
| Floor start bulge position https://ausmini.com/forums/viewtopic.php?f=2&t=94936 |
Page 1 of 1 |
| Author: | Silobin [ Fri Feb 24, 2017 4:54 pm ] |
| Post subject: | Floor start bulge position |
Hi all, I'm hoping someone can help with some measurements. I need to re-fit part of my cars transmission tunnel after it was butchered by a previous owner, but I don't know the exact position and height of the floor starter. Basically I need the measurement from the floor to the flat section where the starter mounts, and also from the front of the floor brace to the starter hole and drivers side inner sill to starter hole! Really appreciate the help folks, Silas |
|
| Author: | metungdan [ Wed Jun 05, 2019 9:20 am ] |
| Post subject: | Re: Floor start bulge position |
Hi there, I have an 850 in rebuild on rotisserie with floors all finished and starter switch metalwork all original. If you send me a picture or hand drawn diagram showing what you need I'll measure up for you. I need similar thing for placement of rodchange into my 850. Cheers Danny 0459 848 863 Sent from my SM-G955F using Tapatalk |
|
| Author: | winabbey [ Wed Jun 05, 2019 11:13 am ] |
| Post subject: | Re: Floor start bulge position |
Danny - that post by Silobin was over 2 years ago so I assume he was sorted. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|