| ausmini https://ausmini.com/forums/ |
|
| rattling rear hand brake lever arm in backing plate https://ausmini.com/forums/viewtopic.php?f=2&t=94313 |
Page 1 of 1 |
| Author: | GundyGuy [ Mon Nov 28, 2016 5:50 pm ] |
| Post subject: | rattling rear hand brake lever arm in backing plate |
Finally found where the rattle was coming from at the rear end The lever arm that the hand brake cable attaches too at the backing plate is rather loose and wobbly Is there a fix for this |
|
| Author: | Phil 850 [ Mon Nov 28, 2016 7:22 pm ] |
| Post subject: | Re: rattling rear hand brake lever arm in backing plate |
There should be a rubber gaiter where the lever comes through the backing plate. This should dampen out any vibration if it's in good condition. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|