Anyone have a really easy to read/understand wiring diagram on how to install? I low key am horrible at wiring, something that says, take the green wire from EDIS and add to such and such would be ideal....
Ta
| ausmini https://ausmini.com/forums/ |
|
| Megajolt wiring diagram for dummies? https://ausmini.com/forums/viewtopic.php?f=2&t=94215 |
Page 1 of 1 |
| Author: | mattsmadmini [ Mon Nov 14, 2016 2:09 am ] |
| Post subject: | Megajolt wiring diagram for dummies? |
Anyone have a really easy to read/understand wiring diagram on how to install? I low key am horrible at wiring, something that says, take the green wire from EDIS and add to such and such would be ideal.... Ta
|
|
| Author: | nicholasatkins [ Mon Nov 14, 2016 3:30 pm ] |
| Post subject: | Re: Megajolt wiring diagram for dummies? |
its pretty easy using the installation guide just follow the numbers. had a quick look at mine on the edis plug no.1 - green/white is the pip signal to mega jolt (shielded cable) no.2 - red / yellow is the saw signal to mega jolt (shielded cable) no.5 - green to - on crank sensor (shielded cable) no.6 - blue to + on crank sensor (shielded cable) no.7 - cable shields + ground no.8 - +12v on edis no.9 - Green/black to ground no.10 - green/yellow to no.1 brown/geen on coil pack no.12 - brown/red to no.3 brown/blue on coil pack no.2 on coil pack purple/black needs a +12v the mega jolt also needs a +12v and ground make sure you use shielded cable for the signal wires to the crank sensor and the mega jolt and earth the sheath and all +12v are switched via ignition. |
|
| Author: | mattsmadmini [ Mon Nov 14, 2016 11:27 pm ] |
| Post subject: | Re: Megajolt wiring diagram for dummies? |
thanks amigo |
|
| Author: | simon k [ Tue Nov 15, 2016 10:06 am ] |
| Post subject: | Re: Megajolt wiring diagram for dummies? |
nicholasatkins wrote: its pretty easy using the installation guide just follow the numbers. had a quick look at mine on the edis plug no.1 - green/white is the pip signal to mega jolt (shielded cable) no.2 - red / yellow is the saw signal to mega jolt (shielded cable) no.5 - green to - on crank sensor (shielded cable) no.6 - blue to + on crank sensor (shielded cable) no.7 - cable shields + ground no.8 - +12v on edis no.9 - Green/black to ground no.10 - green/yellow to no.1 brown/geen on coil pack no.12 - brown/red to no.3 brown/blue on coil pack no.2 on coil pack purple/black needs a +12v the mega jolt also needs a +12v and ground make sure you use shielded cable for the signal wires to the crank sensor and the mega jolt and earth the sheath and all +12v are switched via ignition. noice... I added this to the how-to |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|