ausmini
https://ausmini.com/forums/

Extractors
https://ausmini.com/forums/viewtopic.php?f=2&t=94194		 Page 1 of 1
Author:  GundyGuy [ Thu Nov 10, 2016 11:28 am ]
Post subject:  Extractors
Well from what I can see I will have to cut my lcb extractors to get them out before removing the engine
So am thinking of a new set that are easier to remove install
Any suggestions on brand to get etc

Sent from my HTC_PN071 using Tapatalk
Author:  Scoop [ Thu Nov 10, 2016 1:49 pm ]
Post subject:  Re: Extractors
Dont they split apart or have they been welded?
Author:  GundyGuy [ Thu Nov 10, 2016 1:50 pm ]
Post subject:  Re: Extractors
Welded

Sent from my HTC_PN071 using Tapatalk
Author:  simon k [ Thu Nov 10, 2016 1:51 pm ]
Post subject:  Re: Extractors
keen to see what people say on this one

my current extractors are becoming very 2nd hand and I'm thinking I'll replace them with C-AEG365 Maniflow the joint is back under the floor though which could be a pain

My current set have the joint down behind the motor, the Y piece has the bend in it - it makes it easier to get them off because I welded a little piece of rod between the pipes on the Y and I just belt on that with a long bar and it pops off after a few good whacks. Putting them on is the same...
Author:  simon k [ Thu Nov 10, 2016 2:02 pm ]
Post subject:  Re: Extractors
curious about this one - AEG376

has a different size centre branch which seems reasonable
Author:  drmini in aust [ Thu Nov 10, 2016 2:03 pm ]
Post subject:  Re: Extractors
I find the Maniflow LCB comes apart ok IF you use nickel antiseize in the joint. I used kopr-kote before and it set solid with the heat. Needed Mr Anglegrinder's assistance to remove.
Author:  Lillee [ Thu Nov 10, 2016 3:28 pm ]
Post subject:  Re: Extractors
simon k wrote:
curious about this one - AEG376

has a different size centre branch which seems reasonable


Yeah this is good enough for most people, unless you are running serious HP with a serious cam and want every last bit out of the engine (sacrificing low end). For that you may want to look at large bore or 3 into 1
Author:  jprior2912 [ Thu Nov 10, 2016 5:32 pm ]
Post subject:  Re: Extractors
I have these (C-AEG376)

http://www.minispares.com/product/Class ... o%20search

I really like them, sound nice and maniflow make good stuff. I've taken them apart a few times with no issues.
Author:  Phil 850 [ Fri Nov 11, 2016 7:24 pm ]
Post subject:  Re: Extractors
jprior2912 wrote:
I have these (C-AEG376)

http://www.minispares.com/product/Class ... o%20search

I really like them, sound nice and maniflow make good stuff. I've taken them apart a few times with no issues.


I have these too on a stock 1100S but with a RE266SS cam and a 2.95:1 diff.
Pulls really strong from down low which is great with the tall diff.
Really happy with the combination :D
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/