| ausmini https://ausmini.com/forums/ |
|
| removing pot joints from gear box https://ausmini.com/forums/viewtopic.php?f=2&t=93678 |
Page 1 of 1 |
| Author: | mooman10_0 [ Sun Sep 04, 2016 2:18 pm ] |
| Post subject: | removing pot joints from gear box |
Hi everyone, I have done this a few times using a wedge drift and they usually pop straight off, but one I am working on atm is being a you know what!!! Any tricks people use to get them off if they are being uncooperative? Thanks, Steve |
|
| Author: | drmini in aust [ Sun Sep 04, 2016 3:57 pm ] |
| Post subject: | Re: removing pot joints from gear box |
Drill a hole through the Welch plug inside the joint and lever it out. You can then poke the wire clip to encourage it to enter the splines. |
|
| Author: | mooman10_0 [ Sun Sep 04, 2016 6:33 pm ] |
| Post subject: | Re: removing pot joints from gear box |
Sounds fiddly, will give it a go this week |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|