ausmini
https://ausmini.com/forums/

Mini Fuel Line steel line over braided fuel line
https://ausmini.com/forums/viewtopic.php?f=2&t=92596
Page 1 of 1

Author:  micool [ Tue May 10, 2016 4:39 pm ]
Post subject:  Mini Fuel Line steel line over braided fuel line

hey guys whats everyone feedback on the standard steel fuel lines over the braided ones.
Im going to redo my lines with braided lines from the tank to the engine but have been talked out of it by a few people and not sure which way to go now.


Image

Author:  fuzzy-hair-man [ Tue May 10, 2016 5:16 pm ]
Post subject:  Re: Mini Fuel Line steel line over braided fuel line

I can't remember where I read it but someone was saying that braided line is brutal on any other things it might rub against, rubber lines and it didn't matter anywhere near as much.

What is supposed to be the point of braided fuel lines anyway? Brake lines I understand as there's a lot of pressure to be maintained but fuel... not so much / at all.

I think the hydro / brake covers and channels in the floor pan offer a pretty good amount of protection anyway.

Author:  gtogreen1969 [ Tue May 10, 2016 5:19 pm ]
Post subject:  Re: Mini Fuel Line steel line over braided fuel line

I would not do the entire fuel line. If you want some bling then just do the ends in braided.

Author:  micool [ Tue May 10, 2016 5:28 pm ]
Post subject:  Re: Mini Fuel Line steel line over braided fuel line

Only reson i was going to go with braided was because of the 10m of hose i had left over from one of my old race cars.

Author:  simon k [ Tue May 10, 2016 8:00 pm ]
Post subject:  Re: Mini Fuel Line steel line over braided fuel line

micool wrote:
Only reson i was going to go with braided was because of the 10m of hose i had left over from one of my old race cars.


I reckon that's a good reason...

Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/